LTE Comm MoP Ver2

LTE Commissioning MoP -L2100 + L850 Common System Module (10Mhz) -L700 Standalone System Module (15Mhz)

• Eli Samonte

1

© Nokia Solutions and Networks 2016

LTE Flat Network Architecture

2


LTE Network Management Architecture

3


LTE IP Architecture

4


Bayface connection for 3 Sector L2100/L850 1+1+1 (10Mhz) 1xFSMF + 1xFRGY + F 1xFRCG Macro

5


Bayface connection for 3 Sector L2100/L850 1+1+1 (10Mhz) 1xFSMF + 1xFRGY + F 1xFRCG IBS

6


Bayface connection for 1 Sector L2100/L850 1+1+1 (10Mhz) 1xFSMF + 1xFRGY + F 1xFRCG

7


Bayface connection for 3 Sector L700 1+1+1 (15M hz) 1xFSMF + 1xFRPA

8


Software Matrix

BTSW

Build

FL15A 1.2

9

NetAct

FL15A_ENB_0107_001590


NetAct 15

M ME Ericsson

BTS Manager Installation Computer HW /SW requirement

10


BTS Manager Installation

11



12



13


Comm issioning Overview

14


Setting Laptop IP Address

15


Lunching BTS Manager

16


Updating Software (SW)

17


Updating BTS Software (SW) -LN6 BTS SW is required before upgrade to FL15A 1.2 -Reconnect BTS Manager and press close on Auto-config window. -Re-download BTS SW if incompatible SW alarm is appearing on RF Module.

18


Updating BTS Software (SW)

-Go to Software à Update SW - Browse the BTS SW from directory.

19


-

Locate the FL15A 1.2 SW version.

-

Tick Activate SW and Press Update.

Updating BTS Software (SW) -After site reset, close BTS Manager and re-open again with the new version FL15A 1.2

20


Updating BTS Software (SW) -Re-open BTS Manager and press Close for Autoconfiguration. -Proceed with BTS commissioning only if all the module s are detected.

21


Commissioning (Datafill requirement)

https://drive.google.com/folderview?id=0B7 n976w_zRMVRUljcTlkaWRpMU0&usp=sh aring

22


-Use the SCF from Plannin team. RF and TRS datafill also provided for values clarification.

Commissioning (Start Commissioning)

23


Commissioning (Introduction) -Click Commissioning pane

24


-

Tick BTS and TRS fro Target

-

-Select Template

Commissioning (Introduction2) -Locate the scf file provided by the Planning team.

25


Commissioning (Introduction3) -Press continue then Next.

26


Commissioning (Site Properties) RF Datafill

TRS Datafill 27


Commissioning ( Security) -No Changes press Next.

28


Commissioning ( Physical Layer Interface)

-Enable E1 for synchronization coming from U2100 ToP. -Enable FSM EIF23 as RP3 is NOT Tick -Select the interface in use based from actual connection and TRS datafill

29


Commissioning ( Ethernet Switching)

For L2100/L850 if L700– is cascaded -For L700 that will be cascading from L2100/L850: -Tick QoS aware Ehternet switchin g in us. -Tick VLAN aware switching in use. -Accepted frame types must be “All”.

30


Commissioning ( Ethernet Switching)

For L700 and or (L2100/L850 Only)

-No Changes press Next.

31


Commissioning ( Ethernet Link OAM) -No Changes press Next.

32


Commissioning (Ethernet Link OAM) -No Changes press Next.

33


Commissioning (IP Interfaces -1) -Enter the GBR value from datafill - Transport Network ID =0

34


Commissioning ( IP Interfaces -2) -Traffic shaping = Off

35


-

MTU =1500

-

Values from TRS datafill

Commissioning ( IP Interfaces -3) -Input VLAN values from TRS datafill -Press Update when ask to update the Application Addresses

36


Commissioning ( IP Interfaces -4) -VLAN 2 & 3 QoS not enable

37


Commissioning ( IP Interfaces -5) -VLAN 2 & 3 QoS not enable

38


Commissioning (Quality of Service) -No Changes press Next.

39


Commissioning (Timing over Packet)

-Based on datafill.

40


Commissioning (Application Addresses) -Values from datafill

-Select to change

41


Commissioning (RTT Measurement) -No Changes press Next.

42


Commissioning (IP Security)

43


Commissioning (TRS Synchronization)

-Based on datafill.

44


Commissioning (IPv4 Routing-1) -Enter IPRT-1 gateway.

45


Commissioning (IPv4 Routing-2) -Enter IPRT-2 gateway.

46


Commissioning (IPv4 Routing-3)

-Select VLAN IP’s for Source IP Address values.

47



-Do the same for UserPlane and Control Plane

48



-Do the same for UserPlane and Control Plane

49


Commissioning (IPv1 Routing)

-IPv6 not yet in use

50


Commissioning (IP Filtering) -No Changes press Next.

51


Commissioning (Measurement Configuration) -No Changes press Next.

52


Commissioning (BTS Settings)

53


Commissioning (BTS Synchronization Settings) -Frequency synchronization

-Tick Transmission synchronization

54


Commissioning (Module Settings) -Use optimized cooling

55


Commissioning (RF-Sharing) -No RF-Sharing for LTE

56


Commissioning (Cell Resource [L700])

57


Commissioning (Cell Resource [L2100/L850])

58


Commissioning (LTE Carriers [L2100/L850])

59


Commissioning (LTE Carriers [L700])

60


Commissioning (Antenna Line Management)

61


Commissioning (Antenna Line Settings)

62


Commissioning (Antenna Line Settings-2)

63


Commissioning (EAC)

64


Commissioning (RFM EAC)

65


Commissioning (Radio Network Configuration)

66


Commissioning (Send Parameter)

67


Commissioning (Saving Parameter)

68


LTE Comm MoP Ver2

Recommend Documents