Four's Stage Project: Submitted to the Sulaimani University - College of Science - Department of Physics Supervised by Dr. Omed Ghareb Abdullah
Full description
Simulation Using Promodel
Simulation Using Promodel
Simulation Using PromodelFull description
Simulation Using Promodel
How to do pedestrian simulation using VISWALK is explained in thisFull description
Natural gas dehydration with TEG Design an Natural gas dehydration dehydration unit with TEG as the absorbent. absorbent. The objective of the unit is to treat gas ( dehydrate ) to meet wter dewpoint of -10°C at 6200 kpa pressure. Composition of the gas stream is as follows in dry basis. The stream is saturated with water.
And TEG used is
Contactor data is :
Regenerator feed is heated to 105C in the lean / rich exchanger before entering the regenerator Heat exchanger data is as follows :
Regenerator operating conditions is
There is some loss of TEG solvent . This loss is compensated by a make up pump, pumping about 2 USGPM of Lean TEG solvent.
The Regenerated TEG is cooled before entering the contactor and the heat exchanger data is as follows :
The gas testing facility consists of a testing unit, where TEG is removed and the remaining gas is checked for water dew point. For this add a splitter with the following data
With adjust function find out the water dew point of the stream.