__ 9. Make copies of your color test pattern 82E13120 and verify the machine operation and copy quality. The purpose of this kit is to modify the air flow within the ROS cavity to reduce the ROS contamination, which results in copy quality problems.
Purpose
Note: Machines built after the serial number cut-ins below Note: Machines have the air flow modification installed. XC
XE
GSA
VDR-547558
381-573468X
DUX-193208
351-247573X
DUXN-010687N
DRB-132165
351-136345X
DRBN-005567N
XC= Xerox Corporate
Y-M ROS
XE= Xerox Europe GSA= Government Services Administration
Figure 1
Procedure: __ 1. Perform Repair Procedure 6.1 to remove the C,K ROS Assembly (PL 5.1 # 4) and set it aside.
__ 2. Locate the black air duct in the ROS cavity cavity in the machine (Figure 1). __ 3. Remove the 5.5MM screw securing the silver conductive tape (Figure 2). __ 4. Carefully fold the conductive tape back to access the opening in the black air duct (Figure 3).
__ 5. Thoroughly clean the duct in the area of the opening with Film Remover and a lint free cloth (Figure 3).
__ 6. Remove the backing from the ROHS compliant compliant Seal and apply the Seal over the opening in the air duct. Align the seal to to the bottom and rear of the duct and, then fold the tape over securing it to the top of the air duct (Figure 4).
__ 7. Reinstall the conductive conductive tape and install the 5.5 MM screw removed in Step 3. __ 8. Reinstall the C,K ROS Assembly. Assembly.
Figure 2
Kit part #:
Instruction #:
N/A
Date:
__ 10.. Note: It is recommended that the machine is thoroughly vacuumed to remove any toner contamination in the machine. It is also recommended that the Suction/Ozone Filter (PL 9.1 #1) and the CC Filter (PL 9.3 # 9) are checked for excessive contamination and replaced if contaminated and/or at or near end of life per the HFSI.
